How To Install the Valve Controller?

Follow

The Valve Controller installs without any tools, making the physical installation process very simple. Follow the directions below to physically install the Valve Controller:

1. Close the valve.

valve_closed__with_arrow_.svg

2. Align the fork with the valve handle.

Fork_Alignment.PNG

3. Mount the Valve Controller.

mount_the_valve.svg

3. Push down the valve controller onto your valve. Tighten the clamps while holding the valve controller down.

Fork_Alignment.PNG

5. Make sure that the valve controller is facing in the right direction.

Valve_controller_alignment.PNG

6. Check if the fork is aligned with the valve handle correctly

Fork_allignment.PNG

7. Optional: Plug the remote sensor probe into the valve controller

Remote_Sensor_Probe_Connection.PNG

7. Plug into a power outlet to power on.

Connect_to_Power_Supply.PNG

8. Download the Guardian App from the App Store (for iOS) /Play Store (for Android) or visit www.getguardian.com/app

9. Follow the on-screen instructions to finish setting up your Guardian Valve Controller.

Please watch the video below to understand how to physically install your Guardian Valve Controller

1 out of 2 found this helpful

Comments

2 comments
  • Can you mount the Valve Controller in different positions other than what is shown i.e upright (vertical) , at 90 degrees or upside down?
    Thanks Mike S

  • Yes, as long as the Guardian Valve Controller is engaged properly, you can mount it any position around 360 degrees.

    Regards,

    Matthew C.

Please sign in to leave a comment.