How to Use the Leak Detector


The Leak Detectors can be deployed in numerous ways, depending on the area and type of appliance it is monitoring. All water sensors work using the same principle – two electrical leads are exposed to the water, and the sensor sends a signal when the leads are connected by the water. The Leak Detector has three separate sets of sensors – the Drip Sensor, the Bottom Sensors, and the Remote Sensor Probe. We will look at how to use each of these effectively to monitor for water.  See Figure 1 below:


Figure 1

Drip Sensor

  • The top of the Leak Detector is shaped like a “sink” to direct the smallest amounts of water that drips from above to the Drip Sensor
  • To use the Drip Sensor, place the Water Detector directly underneath drains, pipes, or anything else that might spring a leak
  • The cutout along the straight side of the Leak Detector allows the sensor to be placed along a wall, even with quarter-round molding

Bottom Sensors

  • The bottom of the Leak Detector has three pairs of metal leads, that each act as separate sensors.
  • To use the bottom sensors, place the Leak Detector on a flat surface where you expect water to pool in the event of a leak

Remote Sensor Probe

  • The Remote Sensor Probe has an extremely small form factor to fit underneath appliances and in other tight spaces
  • To use the Remote Sensor Probe, plug the 3.5mm plug into the jack on the Leak Detector, and place the Probe where you would like to monitor for water
  • The Probe can be placed on a surface or it can float in a container (e.g. in a sump pump)
  • The Remote Sensor Probe can be used simultaneously with the Bottom Sensors and the Drip Sensor
  • The Leak Detector has magnets inside to optionally attach the Leak Detector to any magnetic surface while using the Remote Sensor Probe
3 out of 3 found this helpful


  • That’s a great discription of how it works- zero information on how to connect it for use... zero actual information in installation per se.

    Comment actions Permalink
  • The web site is not very user friendly at all- hope the product works better than this site- no useful information for issues arising while attempting to install products ( very difficult to connect to wifi ) cannot easily find any helpful information to fix problem

    Comment actions Permalink
  • My 3 sensors installed fine but after the firmware updated to 3.2.9 I lost all three. Valve Stalled so I removed device and reinstalled and calibrated, all fine there but I cannot install the sensors now. It just stays on the screen stating "Shake to wake sensor" Please help. Joe S

    Comment actions Permalink

Please sign in to leave a comment.